Experimental Physics and
Industrial Control System

Mark Rivers <[email protected]> · Tue, 9 May 2000 13:05:56 -0500

    Folks,

I am about to write device support for the EPICS "motor" record (written by 
Tim Mooney and Ron Sluiter from the APS) for the E500 CAMAC motor
controller.  I just wanted to check if anyone had already done this, perhaps
at the IPNS.  I do have Bob Dalesio's E500 code for the "stepperMotor" record,
so lots of the work is done.

Thanks,
Mark Rivers

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System