I am looking for multi-channel CAMAC-based stepper motor controllers
that have EPICS device support available and are still being
manufactured. Anything out there besides the DSP E500?
Best regards,
Peregrine
--
Dr. Peregrine M. McGehee
Los Alamos Neutron Science Center
MS H820 Los Alamos National Laboratory
(505) 667-3273 Los Alamos, NM 87545
- Replies:
- RE: CAMAC-based stepper motor controllers Darrell Nineham
- Navigate by Date:
- Prev:
Re: Writing to PVs Kay-Uwe Kasemir
- Next:
RE: CAMAC-based stepper motor controllers Darrell Nineham
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
<2005>
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Re: CA information on IOC? Ralph Lange
- Next:
RE: CAMAC-based stepper motor controllers Darrell Nineham
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
<2005>
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
| 
·
Home
·
News
·
About
·
Base
·
Modules
·
Extensions
·
Distributions
·
Download
·