Experimental Physics and
Industrial Control System

David Maden <[email protected]> · Fri, 17 Nov 2006 08:45:52 +0100

Lewis,
Rather than using the PFCU-4 controller, you might consider an alternative
interface method. At the SLS, we are driving several of the XIA PF4 filter
units via Hytec 8001 64 channel binary output modules. This saves us the
need for NIM crates, and we need the 8001 for other actuators in the
beamlines anyway.
Regards, David
-----Original Message-----

From: J. Lewis Muir [mailto:[email protected]]
Sent: Thursday, November 16, 2006 4:50 PM

To: [email protected]

Subject: Driver for XIA PFCU-4 controller
I don't see it listed on the EPICS web site's supported
hardware list,
but has anyone written a driver for the XIA PFCU-4 controller?
 http://www.xia.com/PF_products.html#PFCU
Thanks,
-lewis

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System