IOC Connecting Problem

["Pilkyu Jung"<pilkyu@bmii.co.kr>]

Hi all,

First of all, I am trying to connect from a oscilloscope which name is Agilent Technologies DSO-X 3052A (500 MHz 4 GSa/s) to IOC.

As you can see in the manual(http://literature.cdn.keysight.com/litweb/pdf/75019-97073.pdf , http://www.keysight.com/upload/cmc_upload/All/3000_series_prog_guide.pdf),

this oscilloscope support a few ways (e.g. the IO Library, Telnet Sockets, and using Browser Web Control) for sending SCPI.

However, When I connect to IOC, I got a problem. Until now, I just connected only adjust IP address in st.cmd.

Like this,

drvAsynIPPortConfigure("P1",169.254.90.3:5025,0,0,0)

When I connect by telnet, it is done successfully (please check the Screenshot...image file).

I don't know why this device can't be connected to IOC in this case. Definitely I am done with this way before, but now I can't.

Here is my question,

1. Normally, when you connect from device to IOC, what kind of method use?

2. In my case, How can I connect to IOC?

Best Regards,

Pilkyu Jung

Attachment: Screenshot from 2017-02-15 18_16_44.png
Description: PNG image