Experimental Physics and
Industrial Control System

There is a difference between stepper and servos, yes.

First of all, the controller must support servo motors.
These days many/most controllers come with a vendor-tool
to commission and fine-tune the motors.
Once that is done, we can set up an EPICS IOC to control
the motors through EPICS.

I don't know anything about "max v", so the question really is,
which motion controller do you want to use for the servos ?

HTH
/Torsten


On 2024-04-29 09:13, 백호령 via Tech-talk wrote:

Is EPICS support servo motor control?

We usually use VME, OMS max v by control stepper motor. But we'd like to change stepper to servo.

I'd like to know is any different to control servo motor.

References:

epics servo motor control 백호령 via Tech-talk

Navigate by Date:

Prev: epics servo motor control 백호령 via Tech-talk

Next: Re: epics servo motor control Heinz Junkes via Tech-talk

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  <2024> 

Navigate by Thread:

Prev: epics servo motor control 백호령 via Tech-talk

Next: Re: epics servo motor control Heinz Junkes via Tech-talk

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  <2024>