Argonne National Laboratory

Experimental Physics and
Industrial Control System

1994  <19951996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  Index 1994  <19951996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020 
<== Date ==> <== Thread ==>

Subject: Re: Choice of hardware
From: winans@aps.anl.gov
To: Klaus Woerle <woerle@MPA-Garching.MPG.DE>
Cc: tech-talk@aps.anl.gov
Date: Wed, 09 Aug 95 10:06:50 -0500
>2.  For some reasons, we would prefer using an MVME167 processor board.
>    Are there any EPICS supported modules to combine with a 167 in
>    order to get the job done?

Yah,  HiDEOS includes this capability.  In fact it was the original
design to operate a 162 as a slave to a 167 running vxWorks/EPICS.

I also know that DESY has something similar they have done where they
run vxWorks on the slave 162.  However, I have no idea if they have
serial board support.  You should contact Matthias Clausen at DESY
(claus@heracc.desy.de) he was the guy I talked to about their stuff.

--John


References:
Choice of hardware Klaus Woerle

Navigate by Date:
Prev: Choice of hardware Klaus Woerle
Next: Re: ca_pend_event question (VAX/VMS only) Jeff Hill
Index: 1994  <19951996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020 
Navigate by Thread:
Prev: Choice of hardware Klaus Woerle
Next: correction! Michael Borland
Index: 1994  <19951996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020 
ANJ, 10 Aug 2010 Valid HTML 4.01! · Home · News · About · Base · Modules · Extensions · Distributions · Download ·
· Search · EPICS V4 · IRMIS · Talk · Bugs · Documents · Links · Licensing ·