Experimental Physics and
Industrial Control System

"Eric Bjorklund, NPSM" <[email protected]> · Mon, 16 Mar 1998 15:45:47 -0700 (MST)

Garrett,

>Is there a debug I can invoke to see what 
>the 2992 is reading? I know the data is good as of the CAMAC 
>backplane. After that, how can I tell what it is?

There is a "bcnaf" function included in the util directory.  This should allow
you to issue CAMAC commands from the vxWorks shell and see the raw data that
comes back through the ht2992.

If I were to make a wild guess, I would suspect something screwy is going on
with the range specifications.  Are you using the generic device support, or
one of your own?  What does the CAMAC address specification in the INP field of
the record look like?

==============================================================================
Eric Bjorklund				Voice: 505-667-6031
Los Alamos National Laboratory		Email: [email protected]
AOT-6 MS H820
PO Box 1663
Los Alamos, NM 87545
==============================================================================

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System