We are using the low cost TRI-M MZ104+ board, but we are using it with
VxWorks. We use the ethernet port to supervise/readout PLCs.
http://www.tri-m.com/products/engineering/mz104+.html
http://isacwserv.triumf.ca/isac/pubdoc/icalepcs03_pc104.pdf
- rolf -
Denison, PN (Peter) wrote:
Does anyone have any recommendations for or against any particular PC104
format single-board computer for use as a Linux IOC?
We are considering the Arcom boards (Viper, Vulcan) which run a
400/533MHz Intel XScale processor, and come with a Linux SDK. Is 64MB
RAM and 16MB flash likely to be enough to run EPICS?
Peter Denison, Senior Software Engineer
Diamond Light Source Ltd., Diamond House, Chilton, Didcot, Oxon, OX11
0DE
Tel: +44 1235 778511
--
+-------------------------------------------------+
| Rolf Keitel, TRIUMF Tel: (604) 222-7453 |
| Group Leader ISAC Controls Fax: (604) 222-7307 |
| and Electronics Development |
| Vancouver, B.C., Canada |
+-------------------------------------------------+
- References:
- Suitable PC104 board for EPICS/Linux Denison, PN (Peter)
- Navigate by Date:
- Prev:
RE: CA loss package on 1 Hz rate Jeff Hill
- Next:
RE: CA loss package on 1 Hz rate Liyu, Andrei
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
<2005>
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Re: Suitable PC104 board for EPICS/Linux Jack
- Next:
Re: Suitable PC104 board for EPICS/Linux Arne P. Freyberger
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
<2005>
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
|