Experimental Physics and
Industrial Control System

Eric Norum <[email protected]> · Fri, 16 Mar 2007 15:58:12 -0500

On Mar 16, 2007, at 3:45 PM, Kay-Uwe Kasemir wrote:

On Mar 16, 2007, at 16:29 , Graham Waters wrote:
I notice the output format for date() for R3.14 is difference from
R3.13. In detail

tsStampToText() is replaced by epicsTimeToStrftime(). Is there any
functionality

somewhere to return the name of the month ("Mar" rather than "03").

At least some versions of strftime support these:

%A is replaced by national representation of the full
weekday name.
 %a is replaced by national representation of the
abbreviated weekday

name.
 %B is replaced by national representation of the full month
name.
 %b is replaced by national representation of the
abbreviated month

name.

.. and epicsTimeToStrftime just calls the underlying strftime

after removing the format character for the nanoseconds (if used).
Not sure if that's available on vxWorks, RTEMS, ....

It's available on RTEMS.
--
Eric Norum <[email protected]>
Advanced Photon Source
Argonne National Laboratory
(630) 252-4793