Experimental Physics and
Industrial Control System

Emmanuel Mayssat <[email protected]> · Tue, 10 Jul 2007 11:17:00 -0700

Hello,

When you instantiate a thread in the sequencer, you can use program
macros (logfile, debug, etc) to configure the seqLog (and more)
function.
The issue is that once the seq is started, you cannot change the values
of the macros in iocsh. At least this is what I believed.
As once again, I went through the seq documentation, I stumbled on the
macValueGet function, which apparently would imply that it is possible
to change macro values on the fly. 

If that is the case, how can I change the seq macros in iocsh?
(the idea is to increase/decrease debug level when the seq is RUNNING)

Also what are the user debug level allowed by the seq?
Does seqLog accept debug levels? 
Apparently not... but I could always create my log function.

Regards,

--
Emmanuel Mayssat

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System