Hi everyone~
I'm trying to connect a scope via linux-GPIB. The driver had been
setup and read/write to the scope was successfully tested with
"ibtest"
But when typing in iocsh the command
GpibBoardDriverConfig("L2",1,0,3,0)
I got the error:
2011/03/14 21:48:44.176 L2 addr -1 : EDVR 0: OS error.
2011/03/14 21:48:44.176 L2 addr -1 : EDVR 0: OS error.
........
libgpib: invalid descriptor
libgpib: invalid descriptor
libgpib: invalid descriptor
........ alot of repeat lines.......
Looks like the GPIB device address was not set correctly. However, I
can find no hints in the asyn document for the problem. Is there
anything I missed here?
--
Laurence Feng
Superconducting Radio Frequency Group
State Key Laboratory of Nuclear Physics and Technology
Peking University, 302 Chengfu Road
Beijing 100871 China
- Replies:
- How to use asyn with linux-GPIB Feng Laurence
- Navigate by Date:
- Prev:
where to free memory in asub record? Silver
- Next:
How to use asyn with linux-GPIB Feng Laurence
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
<2011>
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Re: where to free memory in asub record? Andrew Johnson
- Next:
How to use asyn with linux-GPIB Feng Laurence
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
<2011>
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
|