I have written streams support for the LM500, but not noticed this.
Which commands are causing the problems?
-----Original Message-----
From: [email protected] [mailto:[email protected]] On Behalf Of Nicholas P. DiMonte
Currently I'm in the middle of writing a Streams support for a LM-500 Cryogenic Liquid Level Monitor but have discovered that this device will get out of sync with it reply messages, that is part of a reply is in one string while the other half is in another reply string. I'm seriously considering starting over to use the GPIBCVTIO function to clean this up.
--
Scanned by iCritical.
- References:
- Problems sending \x0 with devGpib driver Andrew Wagner
- Re: Problems sending \x0 with devGpib driver Eric Norum
- Re: Problems sending \x0 with devGpib driver Andrew Wagner
- Re: Problems sending \x0 with devGpib driver Eric Norum
- Re: Problems sending \x0 with devGpib driver Dirk Zimoch
- Re: Problems sending \x0 with devGpib driver Nicholas P. DiMonte
- Navigate by Date:
- Prev:
Re: Problems sending \x0 with devGpib driver Nicholas P. DiMonte
- Next:
Re: Problems sending \x0 with devGpib driver Dirk Zimoch
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
<2012>
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Re: Problems sending \x0 with devGpib driver Nicholas P. DiMonte
- Next:
Re: Problems sending \x0 with devGpib driver Dirk Zimoch
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
<2012>
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
|