Experimental Physics and
Industrial Control System

Good afternoon,

I was hoping to use EPICS to control motors through a Newport XPS-C and receive data from an Andor Zyla detector. I have Windows 7 installed with EPICS 3.14.12.4 and synApps 5.7 (motor6-8) but I have been unable to figure out how to connect to my XPS. I have modified st.cmd.xps but haven't been able to connect and control the motors. Is there some sort of tutorial that I have missed online that would be helpful? Right now I'm just looking to connect and maybe move an XYZ stage before moving onto the more complicated trajectory scans that I see tutorials for online.

Thank you,
Andy

Replies:

RE: Setting up Newport XPS-C on Windows 7 Mark Rivers

Navigate by Date:

Prev: Re: MEDM issues Jennings, Guy

Next: RE: Setting up Newport XPS-C on Windows 7 Mark Rivers

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  <2015>  2016  2017  2018  2019  2020  2021  2022  2023  2024 

Navigate by Thread:

Prev: RE: caQtDM evaluation at SLAC Mezger Anton Christian (PSI)

Next: RE: Setting up Newport XPS-C on Windows 7 Mark Rivers

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  <2015>  2016  2017  2018  2019  2020  2021  2022  2023  2024