Experimental Physics and
Industrial Control System

Hi all:

   I have a question again.

   Now, I am using the synApp following the documentation. I want to use KohzuSrc( in motorApps of motor module), but I found the motorApps only has *.cc, not the *.db. 
   So I didn't know how to add the record file( *.db) when I modify the st.cmd.
   Could you tell me how to use it?
   Any idea would appreciate.
   I am the new, so the more the better.
   Thanks a lot.

My computer is Redhat6.0 , epics3.14.12.1, synApp5-6, motor6-7 .

Thanks!
Liang, yaxiang

Replies:

Re: how to use the motorApp in synApps Ron Sluiter

Navigate by Date:

Prev: Support for SRS SR400? Peter Mueller

Next: Re: how to use the motorApp in synApps Ron Sluiter

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  <2015>  2016  2017  2018  2019  2020  2021  2022  2023  2024 

Navigate by Thread:

Prev: RE: Support for SRS SR400? Goetze, Kurt A.

Next: Re: how to use the motorApp in synApps Ron Sluiter

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  <2015>  2016  2017  2018  2019  2020  2021  2022  2023  2024