Experimental Physics and
Industrial Control System

1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 <2019> 2020 2021 2022 2023 2024	Index	1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 <2019> 2020 2021 2022 2023 2024
<== Date ==>		<== Thread ==>

Subject:	CANbus EPICS support
From:	"Gofron, Kazimierz via Tech-talk" <[email protected]>
To:	"'[email protected]'" <[email protected]>
Date:	Fri, 8 Mar 2019 18:40:36 +0000

Hi,

We are about to procure some Hyrel3D.com printheads, which are communicating using CANbus. Is anyone using CANbus with EPICS support?

I searched the tech-talk, and last discussion of CANbus is from about 3 years ago.

Kazimierz Gofron

NSLS-II Controls Group

Brookhaven National Laboratory

(p) +1 (631) 344 5283

(f) +1 (631) 344 8085

Navigate by Date:: Prev: Re: Multi-axis sequenced move using asynMotor pseudo axis Pearson, Matthew R. via Tech-talk; Next: Re: CANbus EPICS support Dr. Bastian Löher via Tech-talk; Index: 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 <2019> 2020 2021 2022 2023 2024
Navigate by Thread:: Prev: RE: Multi-axis sequenced move using asynMotor pseudo axis Mark Rivers via Tech-talk; Next: Re: CANbus EPICS support Dr. Bastian Löher via Tech-talk; Index: 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 <2019> 2020 2021 2022 2023 2024

ANJ, 08 Mar 2019