Hi John,
When the cameras stop do they respond to a ping? If not then they would appear to be really dead and need to be power-cycled.
Ø
If I power cycle a camera which is successfully acquiring, acquisition will stop but I can recover it by pressing 'Stop' followed by 'Start' in the MEDM screen.
But when you do that the EPICS output PVs will in general not agree with the camera values (gain, exposure time, etc.). There is a fix for that in the upcoming ADCore R3-12, but currently you really do need to restart the IOC to have the
camera and EPICS be in sync for those types of settings.
I have attached the 3 slides from my presentation at the 2021 EPICS Collaboration Meeting that describe this new feature to restore camera settings without restarting the IOC.
Mark
From: Tech-talk <tech-talk-bounces at aps.anl.gov>
On Behalf Of John Dobbins via Tech-talk
Sent: Friday, September 17, 2021 12:13 PM
To: tech-talk at aps.anl.gov
Subject: Allied Vision camera oddity
We are using Allied Vision Mako G-319B cameras with ADVimba. (Firmware 00.01.54.21000, SDK 1.8.0, Driver 1.1.0 ADCore 3.7.0)
An odd behavior we have observed is that rarely image acquisition stops. The PV 'Acquire' reports Acquire but the ArrayCounter_RBV stops incrementing.
We have nine cameras on a dedicated subnet connected to the host. Recently, three cameras stopped acquisition simultaneously ( based on the time-stamp of ArrayData). I then started
the Allied Vision Vimba viewer, and these three cameras are not found. I power cycle the cameras and they now appear in the Vimba viewer. However, the IOC cannot reestablish image acquisition. For that I have to restart the IOC.
Each camera is connected to a separate IOC on the host (which happens to be a clustered host).
My speculation is that some sort of glitch on the subnet confuses the cameras which then need to be power cycled to recover. I don't understand why the IOC needs restarting. If
I power cycle a camera which is successfully acquiring, acquisition will stop but I can recover it by pressing 'Stop' followed by 'Start' in the MEDM screen.
Not an urgent problem because it happens so rarely. An annoyance because the camera needs to be power cycled and the IOC restarted.
Research Support Specialist
Cornell High Energy Synchrotron Source