gdct

[Ric Claus <claus@SLAC.Stanford.EDU>]

I recently switched from dct to using gdct and am having troubles.  Almost every 
time that I use the File:Open... selection to open another file after finishing 
with a previous one I get:

[1]    Segmentation fault     gdct

after I push the Open button in the file_chew window.  The first time always works 
fine, but the second almost always fails.  I had the impression that saving the 
file first reduced the failure rate, but I'm not so sure anymore.

My environment is a SUN SPARCstation 5 (it happens on IPCs, too), SunOS 4.1.3, fvwm 
with AutoRaise enabled.

Anyone have any ideas on how to fix this?

	Thanks,
-- 

	Ric Claus	(claus@slac.stanford.edu, (415) 926-2697)