Dear All,
I'm using EPICS R3.13.0.beta11, MV162, VxWorks 5.2 and
GPIB-1014 (Gpib-VME by National Instruments).
I'm testing a gpib device. The rules are two :
1) I must use only EOI true for message termination;
2) All data sent to, or read from, the device must be in
binary, not in ASCII characters.
Now I have a sequence of numbers to execute a device command :
30 0 17 0 0 128
For this test I'm using GPIBInteract, then write:
\x1e\x0\x11\x0\x0\x80
but the device don't execute the command (only busy led
turn on for a second).
Where is my mistake ?
Thanks in advance
Mauro.
- Navigate by Date:
- Prev:
dm on PC's Rolf Keitel
- Next:
GPIB device test mauro
- Index:
1994
1995
1996
1997
<1998>
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
dm on PC's Rolf Keitel
- Next:
GPIB device test mauro
- Index:
1994
1995
1996
1997
<1998>
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
|