Here again, I have to deal with the not-s-straight-forward epics build
system.
So far I always build against the base. I am referring to the
configuration and/or config directories at the top my device source.
In those files the SNC make variable is not set etc.
The sequencer source build correctly but against a local
configuration/config directory.
So far I was able to go from snl to c code and include the c code in my
driver source. But, when I type "help" at the iocsh prompt I do not see
the sequencer commands (such as seqShow, etc).
1/ Where are those commands coming from? A library ?
2/ I include the seq pv seqDev libraries in my ioc. My sequencer.c
program is also added as a SRCS to that same ioc. Everything compile
correctly. But still cannot see the seqShow command in the iocsh help.
What am I not doing correctly ?
--
Emmanuel Mayssat
Cell: 650/793-0626
Lyncean Technologies, Inc.
"See the invisible"
- Replies:
- Re: sequencer installation Eric Norum
- Navigate by Date:
- Prev:
Re: VME Bus Error handling on MVME3100 and MVME6100 board Kate Feng
- Next:
Re: sequencer installation Eric Norum
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
<2006>
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Re: VME Bus Error handling on MVME3100 and MVME6100 board Kate Feng
- Next:
Re: sequencer installation Eric Norum
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
<2006>
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
|