Show alarms, events and measurements from DSP in CS-Studio and generate files with this data

[Carlos Gómez Martinez <c.gomez@jemaenergy.com>]

Hi ,

 

I am Carlos from Spain and I am developing an HMI, it consists of:

A DSP sends measurements, alarms and events through modbus addresses, these data are converted to EPICS and displayed on screen with CSS. The "brain" of the project is the DSP, ie, alarms are not made by epics, alarms are generated by the DSP and the cs-studio is only displayed if there is failure, if there is no fault, measures etc .. I would know how these failures can be collected, events and actions and how I can build a table in CS-Studio where these data to be displayed and also to generate a file with this data.

 

Thanks,

 

Carlos