Experimental Physics and
Industrial Control System

[email protected] · Mon, 8 Aug 2016 12:30:38 +0530

Hi,
   I am trying to start an epics driver for Basler scA-1390-17gc camera.
I copied the github repository from
https://github.com/sesamecs/basler-gige.git

I installed pylon3 in /opt directory and started camera with Pylonveiwer.

But when I start epics driver from the above repository following error
messages are shown.
Exception: Failed to write enumeration value. Enum entry is not
writableUnable to initialize driver thread
Unable to read BOC03-DI-CAM1:getExposure: Driver thread is unable to read
Unable to read BOC03-DI-CAM1:getGain: Driver thread is unable to read
Unable to read BOC03-DI-CAM1:getHeight: Driver thread is unable to read
Unable to read BOC03-DI-CAM1:getSize: Driver thread is unable to read
Unable to read BOC03-DI-CAM1:getOffsetY: Driver thread is unable to read
Unable to read BOC03-DI-CAM1:getWidth: Driver thread is unable to read
Unable to read BOC03-DI-CAM1:getGainAuto: Driver thread is unable to read
Unable to read BOC03-DI-CAM1:getOffsetX: Driver thread is unable to read
Unable to read BOC03-DI-CAM1:getTriggerSource: Driver thread is unable to
read

apart from these I am also getting error
"../../../src/ioc/rsrv/online_notify.c: CA beacon (send to
"127.0.0.1:5065") error was "Connection refused"
Please duide me how to start this epics driver.
Thank you

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System