Experimental Physics and
Industrial Control System

Simon Reiter <[email protected]> · Tue, 30 Jan 2018 17:25:28 +0100

Hi all,

I ran into another problem.

Using the sequencer (2.2.4) for a state machine was working well. With

the upgrade to EPICS 3.16.1,

some states seem to be skipped. Normally, it would go like READY ->

STARTING -> RUNNING.

I added log messages to verify these states. This is fine.

But using camonitor only show READY -> RUNNING.
The same happens for external software, which uses a channel subscription.
This problem also happens in EPICS7.

Any idea, how I can solve this without implementing some delay workaround.

Cheers,
Simon

--
Simon Reiter
II. Physikalisches Institut
Justus-Liebig-Universtität
Heinrich-Buff-Ring 16
D-35392 Giessen
Tel: +49 641 99 33250

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System