| 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 <2018> 2019 2020 2021 2022 2023 2024 | Index | 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 <2018> 2019 2020 2021 2022 2023 2024 |
| <== Date ==> | <== Thread ==> |
|---|
| Subject: | Re: Sequencer seem to skip states with EPICS 3.16.1 |
| From: | "Hartman, Steven M." <[email protected]> |
| To: | Simon Reiter <[email protected]> |
| Cc: | EPICS Tech Talk <[email protected]> |
| Date: | Wed, 7 Feb 2018 23:00:37 +0000 |
> On Feb 7, 2018, at 5:31 PM, Simon Reiter <[email protected]> wrote:
>
>> state check {
>> when(pv_mem < 2) {
>> } state check_valid
>> when(pv_rate != 0) {
>> } state check
>> when(pv_rate == 0 && delay(Waittime)) {
>> } state check_failed
>> }
I would avoid the
when(pv_rate != 0) {
} state check
in the check state as that will just loop, burning CPU. Try something like this . . .
state check {
when(pv_mem < 2) {
} state check_valid
when(pv_rate == 0 {
} state check_delay
}
state check_delay {
when(pv_rate != 0) {
} state check
when (pv_rate == 0 && delay(Waittime)) {
} state check_failed
}
--
Steven Hartman
[email protected]