Experimental Physics and
Industrial Control System

Hi all,

 

I’m struggling to get an IOC to connect to my BlackFly S camera which uses Spinnaker software.  I’m using the HEAD revision of areaDetector with ADCore, ADSupport and ADSpinnaker from the GitHub.

I’ve managed to build all components but when I start the IOC, it fails to connect to the camera:

 

ADSpinnakerConfig("SP1", 18260782, 0x1, 0)

2018/09/19 14:48:27.180 ADSpinnaker:connectCamera: no cameras found

2018/09/19 14:48:27.180 ADSpinnaker:ADSpinnaker:  camera connection failed (3)

Number of cameras detected: 0

 

I can see the camera using arv-tool-0.4 from aravisGigE component and list it’s feature without any problems.

 

Here’s my setup, as per documentation:

-          Ubuntu 16.04

-          GLIBC 2.23

-          GLIBCXX 3.4.21

-          GCC 5.4

 

Has anyone managed to get the IOC to talk to BlackFly S, model: BFS-PGE-16S2M-CS?

 

Thanks,

Andraz Pozar Controls Engineer Australian Synchrotron Tel Email Web +61 3 8540 5387 [email protected] www.ansto.gov.au

Important: This transmission is intended only for the use of the intended addressee. It is confidential to the intended addressee and may contain privileged information and or copyright material. If this email is not intended for your attention, any use, printing, storage, reproduction or further disclosure of this communication (including all attachments) is strictly forbidden. If you have received this transmission in error, please notify me by telephone or email and immediately delete all copies of this transmission as well as any attachments.