Experimental Physics and
Industrial Control System

1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 <2020> 2021 2022 2023 2024	Index	1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 <2020> 2021 2022 2023 2024
<== Date ==>		<== Thread ==>

Subject:	MEMD is stuck on windows-x64
From:	杨栋亮 via Tech-talk <tech-talk at aps.anl.gov>
To:	tech-talk at aps.anl.gov
Date:	Thu, 20 Feb 2020 16:23:14 +0800 (CST)

Dear All,

I installed the following softwares on the Windows_7_x64 system:

* Microsoft Visual Studio Community 2019

* Strawberry-perl-5.30.1.1

* EPICS base-7.0.3.1

* Hummingbird Exceed v13

* EPICSWindowsTools1.44-x64.msi

====================================

The problem is:

I can run IOC and edit MEDM normally.

But, when I execute a MEDM, the MEDM responds to the button events very slowly, although displaying PVs normally.

When I switch to edit mode, the MEDM disconnects with IOCs and is stuck .

At this time, I can new a MEDM and edit it normally. But when I switch it to execute mode, the same problem would happen immediately.

====================================

Have others seen similar problems? What could be wrong?

Thanks,

Yang

Navigate by Date:: Prev: MEMD is stuck on windows-x64 杨栋亮 via Tech-talk; Next: Galil new "all in one" multi-axis amplifier [DLM=For-Official-Use-Only] CLIFT, Mark via Tech-talk; Index: 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 <2020> 2021 2022 2023 2024
Navigate by Thread:: Prev: MEMD is stuck on windows-x64 杨栋亮 via Tech-talk; Next: Re: MEMD is stuck on windows-x64 Mark Rivers via Tech-talk; Index: 1994 1995 1996 1997 1998 1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 <2020> 2021 2022 2023 2024

ANJ, 20 Feb 2020