Hello Community!
A soft X-ray beamline will be built at SESAME soon and the detector to be used is the Bruker QM100. I know that the MCA module supports this detector, but under windows only, and our standard OS is CentOS for every control system. So my
question is, if anyone developed an IOC for this detector under windows, can you please share your experience running the IOC? What was your setup (Windows, compiler, EPICS and modules)? Were there any difficulties in building and running the IOC, data acquisition,
etc. or any other issue?
One of our colleagues suggested that we might use the DANTE digital pulse processor from XGLab as a readout system for the QM100, it has an EPICS driver and Ethernet interface so that is another route we can go. Does anyone have experience
with this pulse processor?
Best Regards,
Abdalla.