Hi everyone,
is someone using (or have ever used) a
TIP850 Industry Pack module from TEWS with EPICS?
I have a SBS/GreenSpring VIPC616 VME-card which carries two of such modules. I can compile a RTEMS-IOC with the
epics ipac-module running on a MVME2100. The IOC finds the VIPC616 card with the two TIP850 modules:
ipacAddVIPC616(0xD000,0x80000000)
.
.
192.168.99.250> ipacReport(2)
IP Carrier 0: SBS/GreenSpring VIPC616, 4 slots
C0 S0 : 0xb3/0x09
ID = 0x9fffd080, I/O = 0x9fffd000
C0 S1 : 0xb3/0x09
ID = 0x9fffd180, I/O = 0x9fffd100
C0 S2 : No IPAC ID
ID = 0x9fffd280, I/O = 0x9fffd200
C0 S3 : No IPAC ID
ID = 0x9fffd380, I/O = 0x9fffd300
Do I need an additional driver for the TIP850 to connect to the I/O-channels?
The epics ipac-module has support for the
TIP810 CAN bus interface. Would a TIP850 driver look similar to this one?
Best regards
Michael
Michael Sintschuk
Bundesanstalt für Materialforschung und –prüfung (BAM)
8.5 Mikro-ZfP
Unter den Eichen 87
12205 Berlin
GERMANY
P: +49 30 8062-15063 (BESSY, Adlershof)
P: +49 30 8104-4065 (BAM, Steglitz)
michael.sintschuk at bam.de
michael.sintschuk at helmholtz-berlin.de