Re: Recommended setting for XyCom 566 Analog input module?

[Andrew Johnson <anj@ast.cam.ac.uk>]

On Fri, 05 May 1995 17:31:02 PST Tony Cox - (415)926-3105 wrote:

> 	Here's a novice question. I'm starting to set up the hardware for
> our beamline (all dealings with EPICS so far have been theoretical(!)), and
> so I'm trying to interface my first module, the XVME-566.
> 
> 	Naturally, there are numerous jumpers and options. CSR addresses,
> data RAM addresses, interrupt levels etc. Quite a jumble for the first
> module.
> 
> 	Can anyone give me a quick, simple, tutorial on what the appropriate
> values should be, and how these might relate to the DCT VME parameters
> Card/Signal/Parameter?

I have worked out most of the jumper settings for the XVME-566 for Gemini, and 
they are described in my Standard Controller Hardware Documentation, available 
at the following URLs:

	http://www.ast.cam.ac.uk/~anj/gemini/hardware.ps.Z
	ftp://ftp.ast.cam.ac.uk/pub/gemini_RGO/sic/sic_anj_hardware.ps.Z

I can't guarantee 100% that they are all accurate, but I think they should be 
correct.

- Andrew

  O o ._    Andrew Johnson, Royal Greenwich Observatory
     __\\_	Madingley Road, Cambridge, CB3 0EZ
  __|ooooo|__	Tel +44 (0)1223 374823  Fax 374700
~~\_________/~~	WWW http://www.ast.cam.ac.uk/~anj/