Experimental Physics and
Industrial Control System

"guobao shen" <[email protected]> · Wed, 28 Aug 2002 19:48:45 +0800

Hello, every one,
I am a newbie about PENTEK DSP system.

Now I wish to use PENTEK 4284 in my EPICS system, IOC is MVME2302-MPC 603p. After I finish
the configuration of DSP system, I want to run my testing program, which outputs some strings
to VxWorks target-based shell. But it does.

I dont know what is wrong. Can any one give me any advice?

-----my application program -----------------
#include <stdlib.h>
#include <snstdio.h>
main()
{
     plog("I succeed!");
     printf("Hello, PENTEK DSP!\n");
}
---------------end ------------------------ 
-------some information copied from target-based shell-------------
-> sp snio,"mv2302 ptk4284 0"
task spawned: id = 0x1b622f8, name = t1
value = 28713720 = 0x1b622f8
->
SNIO - SwiftNet(TM) I/O Server, Revision 3.5.2
Copyright (c) 2000, Pentek, Inc. All Rights Reserved

0x1b622f8 (t1): [adj_sockbuf] setting socket buffer lengths to 4136
0x1b622f8 (t1): [adj_sockbuf] SNDBUF=4136, RCVBUF=4136

SNVIRT - SwiftNet(TM) Virtual Target Server, Revision 3.5.2
Copyright (c) 2000, Pentek, Inc. All Rights Reserved

0x1bdfcf8 (tSN): device registered: "snio-mv2302-ptk4284-0" (3)
[snio] server running: mv2302:snio-mv2302-ptk4284-0:0

-> pnload "mv2302 ptk4284 0 test4284.out"

0x1be69b0 (tShell): [adj_sockbuf] setting socket buffer lengths to 4136
0x1be69b0 (tShell): [adj_sockbuf] SNDBUF=4136, RCVBUF=4136
[sigvio_boot] (4284,1,0) ........... 0x80000829, 0x00000400
value = 0 = 0x0
->
---------------------end--------------------

Thanks and Regards,
-----------------------------------
guobao shen
Shanghai Synchrotron Radiation Facility, SSRF
Phone: (86 21) 3998 5017
email: [email protected]

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System