On 17:24 Mon 21 Mar , Eric Norum wrote:
>
> > I assume I have to generate the X waveform = # samples on frequency range.
> > But can medm autoscale on the horizontal axis since range and # of samples can be changed at every scan by operator?
> > (I believe so, but ...)
>
> Yes, but remember that the waveform record does not post monitors on its .NORD field. Thus it's a good idea to have a dummy longin record that is forward linked from the waveform record and which gets its value from the waveform record .NORD field and then have MEDM monitor the number of samples to display from that longin record.
Ok, ... but where in the medm display do I specify this longin record?
--
Emmanuel
- Replies:
- Re: non-normalized X WaveF / Y WaveF display Eric Norum
- References:
- non-normalized X WaveF / Y WaveF display emmanuel_mayssat
- Re: non-normalized X WaveF / Y WaveF display Eric Norum
- Navigate by Date:
- Prev:
Re: non-normalized X WaveF / Y WaveF display Eric Norum
- Next:
Re: non-normalized X WaveF / Y WaveF display Eric Norum
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
<2011>
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Re: non-normalized X WaveF / Y WaveF display Eric Norum
- Next:
Re: non-normalized X WaveF / Y WaveF display Eric Norum
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
<2011>
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
|