Experimental Physics and
Industrial Control System

Eric Norum <[email protected]> · Tue, 3 Jan 2012 19:53:53 -0800

The difference is that -DMY_DO_BOOTP=rtems_bsdnet_do_bootp tells the BSP to get the board network configuration from a BOOTP/DHCP server while -DMY_DO_BOOTP=NULL tells the BSP to get the network configuration from the NVRAM.

On Jan 3, 2012, at 7:46 PM, Michael Davidsaver wrote:

> Hello Qazi,
> 
> There is support in RTEMS for the mvme2307 which is used with epics at
> NSLS.  The epics build config used (see attached) is very similar to
> that of the mvme2100.
> 
> The only real difference that I can see from the 2100 config is
> 
>> #ARCH_DEP_CFLAGS += -DMY_DO_BOOTP=NULL
>> ARCH_DEP_CFLAGS += -DMY_DO_BOOTP=rtems_bsdnet_do_bootp
> 
> I don't know what necessitated this though.
> 
> I hope that this is helpful.
> 
> Michael
> 

-- 
Eric Norum
[email protected]

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System