Experimental Physics and
Industrial Control System

Tim Mooney <[email protected]> · Thu, 9 Feb 2012 07:16:22 -0600 (CST)

Hi J. F.,

The Struck 3820 is supported by Mark Rivers, both as a scaler and as a multichannel scaler.
The driver and the mca record (for MCS support) are in the mca module
   http://cars.uchicago.edu/software/epics/mca.html
and the scaler record is in the std module
   http://www.aps.anl.gov/bcda/synApps/std/std.html.

Tim

----- Original Message -----
> From: "GOURNAY Jean-Francois" <[email protected]>
> To: [email protected]
> Sent: Thursday, February 9, 2012 5:08:36 AM
> Subject: VME SCALER, I2C bus
> Hello,
> 
> 
> 
> We are looking for a VME scaler with EPICS support for the Beam Loss
> Monitors we will used in the frame of IFMIF-EVEDA project.
> 
> I saw some discussion between Mark Rivers and Jay Steele in 2010
> concerning the Struck 3820 board. Is this module really supported with
> 3.14. If yes by who?
> 
> 
> 
> Another question, we are also considering the use of I2C bus for the
> configuration of the 200 thresholds of the FE electronics of these
> monitors. Is there some experience of the use of this bus in the
> community?
> 
> 
> 
> Thanks
> 
> 
> 
> J.F. Gournay
> 
> CEA Saclay

-- 
Tim Mooney ([email protected]) (630)252-5417
Software Services Group (www.aps.anl.gov)
Advanced Photon Source, Argonne National Lab

Experimental Physics and Industrial Control System

Experimental Physics and
Industrial Control System