Re: Binary record that recover its value after changed

[Rolf Keitel <rolf@triumf.ca>]

Antonio,

set the HIGH field of the binary output record to the number of seconds you want it to stay at 1.

- rolf -

On 2/13/2014 6:45 AM, Antonio Borondo wrote:

Hi,

 

I have defined a binary output for a command in EPICS which always is 0. If the user change the value to 1 (by a CSS/BOY interface) it must change to 0 again after a few seconds. How can I do that?

 

Thank you very much,

 

Antonio Borondo

-- 
+-------------------------------------------------------+
| Rolf Keitel, Ph.D.                Tel: (604) 222-7453 |
| TRIUMF                                                |
| Vancouver, B.C., Canada                               |
+-------------------------------------------------------+