Experimental Physics and
| |||||||||||||||||
|
Hi again, I've just talked with CAEN's supports and there isn't a support module to communicate with that digitizer. Before I did not get that mail from them, I was dealing with the asynUSBTMC and asynPortDriver. In USBTMC, I could not handle anything with that. I don't know what the problem is. It keep says that : # Configure hardware # usbtmcConfigure(port, vendorNum, productNum, serialNumberStr, priority, flags) usbtmcConfigure("usbtmc1") st.cmd line 18: Command usbtmcConfigure not found. asynSetTraceIOMask("usbtmc1",0,0x2) st.cmd line 19: Command asynSetTraceIOMask not found. asynSetTraceMask("usbtmc1",0,0x03) st.cmd line 20: Command asynSetTraceMask not found. However, in PortDriver, I am just using test application,but I don't understand how it works, does it support USB port ? If it supports, how can i configurate it (in st.cmd file) ? I'm searching how to communicate with the digitizer by doing these applications. If there are another suggestions, I would be pleasure to know them.. Thanks in advance.. Best Regards.. Hulusi Oz 2016-07-29 9:54 GMT+03:00 Hulusi Öz <[email protected]>:
| ||||||||||||||||
ANJ, 29 Jul 2016 |
·
Home
·
News
·
About
·
Base
·
Modules
·
Extensions
·
Distributions
·
Download
·
· Search · EPICS V4 · IRMIS · Talk · Bugs · Documents · Links · Licensing · |