Hi,
I have a device that comes with a command that reads an event log like so:
-> GET ERRORS
<- BEGIN ERRORS
<- 2017-03-16 17:37:52 Cooling Water Flow Error VALUE 1.9
<- 2017-03-16 17:38:13 Sensor 1 Over-Temp Error VALUE 36.7
<- 2017-03-16 17:38:24 Sensor 2 Over-Temp Error VALUE 40.2
<- END ERRORS
Note that the number of lines between the begin and end markers can
vary. There is another command for clearing the event log.
Is there any chance I can read this into either
a) a waveform of strings or
b) one huge waveform of chars?
I'm also open to suggestions on how to improve the protocol. Should I
try to convince the vendor to replace the error log by a command for
reading out the status of all error flags? I could then easily push them
into individual PVs. That would make archiving etc. easier.
Thanks,
Martin
--
Martin Konrad
Control System Engineer
Facility for Rare Isotope Beams
Michigan State University
640 South Shaw Lane
East Lansing, MI 48824-1321, USA
Tel. 517-908-7253
Email: [email protected]
- Replies:
- Re: Streamdevice & variable length data Dirk Zimoch
- Navigate by Date:
- Prev:
Re: Asyn 4-30 Problem on Arm processor Konrad, Martin
- Next:
AreaDetector / ADURL queries Heesterman, Peter J
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
<2017>
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Re: Asyn 4-30 Problem on Arm processor Jörn Dreyer
- Next:
Re: Streamdevice & variable length data Dirk Zimoch
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
<2017>
2018
2019
2020
2021
2022
2023
2024
|