Experimental Physics and
Industrial Control System

OK, thanks I'll see what the PLC guys says about that.  That was my first thought, but then I didn't see how on the PLC side to direct the send-block mechanism to an ipaddr:port .

-ps

On Fri, Oct 20, 2017 at 1:24 PM, Zimoch Dirk (PSI) <[email protected]> wrote:

Hello Paul,

If you cannot increase the block size (the driver has no limit on this but maybe the PLC) you can have two blocks on the PLC running on different ports. To the IOC this would look like two devices.

Dirk

Am 20.10.2017 um 19:18 schrieb Paul Sichta <[email protected]>:

I have been using s7plc driver for years with one SND and one RCV block on the PLC.  Now, we need to send more data than can fit in the (max size) 240-byte block.  How can I send more data to EPICS?  

Regards,

-ps