AW: RE: Has anyone written an IOC for control of (PI)Acton spectrometers?

[Joern Dreyer via Tech-talk <tech-talk at aps.anl.gov>]

Hi,

as these spectrometers use a simple command set that is described in a document by PrincetonImszruments, a simple StreamDevice protocol file can be written to control these devices.

I have done that but currently do not have access to the file. Can send it on monday.

Regards Jörn

---- Mark Rivers via Tech-talk schrieb ----

I am not aware of a driver for PI-Acton spectrometers other than ADLightField.

 

Mark

 

 

From: Tech-talk <tech-talk-bounces at aps.anl.gov> On Behalf Of Heesterman, Peter J via Tech-talk
Sent: Friday, September 11, 2020 10:54 AM
To: EPICS Tech-Talk <tech-talk at aps.anl.gov>
Subject: Has anyone written an IOC for control of (PI)Acton spectrometers?

 

Hi,

 

If the answer is no, I will be likely to write one.

 

I note this question touches on the discussion at https://epics.anl.gov/tech-talk/2019/msg00470.php.

 

I’m aware that ADLightField could be used to operate both Princeton cameras, and Acton spectrometers.

 

But we often use the spectrometer with cameras other than Princeton - and would prefer to use the ADPICam camera driver, if we are.

 

Many thanks,

 

Peter.

 

 

 

Peter Heesterman

Software Engineer

CODAS & IT

Providing services on behalf of United Kingdom Atomic Energy Authority

Culham Science Centre, Abingdon, OX14 3DB, UK

Tel. +44 1235 465157

Email: Peter.Heesterman at UKAEA.uk

Section mail address: PCDatanet-Support at ukaeauk.onmicrosoft.com

 

 

  

 

The content of this email is confidential and intended for the recipient specified in the message only. It is forbidden to share any part of this message with any third party, without the written consent of the sender. If you received this message by mistake, please reply to this message and then delete it, so that we can ensure it does not occur in the future.