Experimental Physics and
Industrial Control System
|
|
Subject: |
nPoint motor driver |
|
From: |
Randall Cayford via Tech-talk <[email protected]> |
|
To: |
"Engbretson, Mark S. via Tech-talk" <[email protected]> |
|
Date: |
Fri, 5 Nov 2021 10:52:20 -0700 |
I’m trying to set up an nPoint LC402 motor controller and I can’t figure out how to load the motor positions. There is a driver in the synApps motor modules and the documentation talks a lot about controlling the stepping through the wavetable but I can’t figure out what PVs I’m supposed to use to set the wavetable values.
Does anyone know how to upload the wavetable to an nPoint controller?
Randall
- Replies:
- Re: nPoint motor driver Kevin Peterson via Tech-talk
- Navigate by Date:
- Prev:
Re: Re:RE: archiver appliance start failed Wilson, Andy (DLSLtd, RAL, LSCI) via Tech-talk
- Next:
Re: IOC in Docker not responding to caget from another host Paduan Donadio, Marcio via Tech-talk
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
<2021>
2022
2023
2024
2025
2026
- Navigate by Thread:
- Prev:
Re: Archiver Appliance configuration questions Shankar, Murali via Tech-talk
- Next:
Re: nPoint motor driver Kevin Peterson via Tech-talk
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
<2021>
2022
2023
2024
2025
2026
|
|
ANJ, 19 Mar 2026 |
·
Home
·
News
·
About
·
Talk
·
Base
·
Modules
·
Extensions
·
·
Distributions
·
Download
·
Documents
·
Links
·
Licensing
·
|
