Hi EPICS community,
I have a question regarding the sscan record.
BtW I am using sscan R2-11-5 and base 7.0.6.1 running on CentOS 7.9.2009.
I am using the scan1 record to drive positioner 1 in LINEAR mode.
I am using a dummy T1PV bo record.
I have setup D01PV to monitor a convenient scalar PV.
And I have set ATIME to 1.0
As the scan progresses, with camonitor, I can see the expected updates
for scan1.D01CA, however I do not get any updates for scan1.P1CA.
Is this expected? Is there some other sscan record field I need to set
in order to get the P1CA updates posted?
I do get updates for P1RA for the previous scan.
Any help/advice appreciated.
Regards
Andrew Starritt
Australian Synchrotron.
OFFICIAL