Experimental Physics and
Industrial Control System

Hi,

Before I ask a question, I would like to thank the epics tech talk for helping me. I’m a beginner in epics and RTOS, but I was able to come to this step with a lot of help. Really appreciate it.

I try to boot MVME6100 with epics st.cmd, MAXv controller. But it shows me a error like this :

Done executing startup script 'host:/usr/local/epics_motor/synApps_5_8/support/motor-6-9/iocBoot/SX_PTL_motor/st2.cmd'.

-> save_restore: connect failed for channel 'BL:SX:EH:ATT1:M1.DVAL'

save_restore: connect failed for channel 'BL:SX:EH:ATT1:M1.DIR'

save_restore: connect failed for channel 'BL:SX:EH:ATT1:M1.DESC'

    ….

    …

save_restore: connect failed for channel 'BL:SX:EH:ATT1:M2.SREV'

save_restore: connect failed for channel 'BL:SX:EH:ATT1:M2.UREV'

save_restore: connect failed for channel 'BL:SX:EH:ATT1:M2.CNEN'

SX_PTL_settings2.sav: 0 of 106 PV's connected

So I think this error is related to st.cmd, wrong set address about MAXvSetup.(I guess)

I set up this st.cmd maxvsetup like this:

MAXvSetup(1, 16, 0x1000, 0, 5, 10)

And my Maxv controller jumper set is like this:

J12 Mode: A16

J12 IRQ : IRQ5

J13 left : A29, A30, A31

J13 right : AM1, AM2, AM4

I set the 8 jumpers on the left of J13 like this and put a value MAXvSetup(1, 16, 0x1000, 0, 5,10). I read Maxv User Manual as well, but I still don’t understand about this.. Do you have any solution about this?