Experimental Physics and
Industrial Control System

Hi,

I had a problem with phobus, when phoebus and alarm-server are on the same server, it runs without problems. But when I put phoebus-product on the client side and alarm-server on the server side, run ./phoebus.sh on the client side, and run ./alarm-server.sh on the server side, the phoebus connection fails, showing ‘No Alarm Server Connection’.

Kafka running on the service end is no problem. The configuration file settings .ini is as follows:

org.phoebus.pv.ca/addr_list=10.101.1.1

org.phoebus.applications.alarm/server=10.101.8.1:9092

org.phoebus.applications.alarm/config_alarm=Accelerator

org.phoebus.applications.alarm/config_alarm=Accelerator,Demo

I don't think there's anything wrong with that.

What is the reason for this error?

Thanks,

xiaomin

Replies:

Re: Phoebus configuration and PV connection Najm Us Saqib via Tech-talk

Navigate by Date:

Prev: RE: USBCTR08 ch0 scaler counts missing Mark Rivers via Tech-talk

Next: Re: USBCTR08 ch0 scaler counts missing Keith Surrena via Tech-talk

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  <2023>  2024 

Navigate by Thread:

Prev: RE: USBCTR08 ch0 scaler counts missing Mark Rivers via Tech-talk

Next: Re: Phoebus configuration and PV connection Najm Us Saqib via Tech-talk

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  <2023>  2024