Re: SPI-MAXNET8000

[Mark Rivers via Tech-talk <tech-talk at aps.anl.gov>]

Servo motor control is supported by the motorOmsAsyn module.  You just need to send the commands to configure a channel for servo operation.  Read the MAXnet manual to see how to do that.  You can save the settings to non-volatile memory.

I don't think the driver currently supports the DAC/ADC or digital I/O bits.  But that can be added to the driver.  You can look at other drivers like SPiiPlusAuxDriver.cpp in motorAcsMotion to see how to do this.

Mark

---

From: hejian at zjlab.org.cn <hejian at zjlab.org.cn>
Sent: Friday, September 2, 2022 8:07 AM
To: Mark Rivers <rivers at cars.uchicago.edu>
Subject: 回复: Re: SPI-MAXNET8000

 

Dear Mark Rivers,

     Thank you ver much for your help, the link you gived is great, it tell me how to control the step motor, but, i want to control serve motor and DAC/ADC, Can you tell me how to solve the problem.

Best Regards!

---

HE JIAN

Shanghai Advanced Research Institute,

Chinese Academy of Sciences

No.99 Haike Road, Zhangjiang Hi-Tech Park,

Pudong New District, Shanghai, China

 Tel: +86-02120302649 E-mail: hejian at zjlab.org.cn

 

发件人： Mark Rivers

发送时间： 2022-09-02 20:40

收件人： tech-talk at aps.anl.gov; hejian at zjlab.org.cn

主题： Re: SPI-MAXNET8000

You can find the EPICS driver for the MAXnet here:

https://github.com/epics-motor/motorOmsAsyn

Mark

---

From: Tech-talk <tech-talk-bounces at aps.anl.gov> on behalf of hejian--- via Tech-talk <tech-talk at aps.anl.gov>
Sent: Friday, September 2, 2022 2:57 AM
To: tech-talk at aps.anl.gov <tech-talk at aps.anl.gov>
Subject: SPI-MAXNET8000

 

Dear experts:

     Would you kindly provide the EPICS IOC for SPI-MAXnet8000, to Realize the open closed-loop control of stepper motor, serve motor control, and ADC\DAC.

Best regards,

Thank you very much.

---

HE JIAN

Shanghai Advanced Research Institute,

Chinese Academy of Sciences

No.99 Haike Road, Zhangjiang Hi-Tech Park,

Pudong New District, Shanghai, China

 Tel: +86-02120302649 E-mail: hejian at zjlab.org.cn