RE: Problem with MVME167-02B boards

[Mark Rivers <RIVERS@cars3.uchicago.edu>]

Re: my previous message:

> I just got two new Motorola MVEME167-02B boards.  I installed the vxWorks 5.1
> ROMs and tried swapping them into an IOC in place of an old MVME167.  vxWorks
> boots and EPICS starts, but there is one huge problem: no VME A16 devices are
> visible.  If I put the old MVME167 back in it works fine.  With the new board
> all non-VME devices work fine, but no VME A16 addresses respond.

It was a silly mistake. I had also installed an MV162 board to run HiDEOS and
had left an empty slot in the VME backplane.  Everything is fine now. Thanks
to John Winans!
                                                Mark Rivers