Experimental Physics and
Industrial Control System

We are attempting to setup an EPICS build enviroment on a PC running
Linux.  I have run into two difficulties.
1. I had to add an extra -B<bin path> to GCC.  This specifies the
location of the cross assembler, as.
2. The build stops with an error.
***No rule to make target `../../bin/mv162/vxWorks', needed by
`buildInstall'.  Stop.

Now the questions:
We use gcc as for cross compiles and for host compiles.  How do I keep
the two separate with hacking the GCC command line?

Is there a clean way to remove the error message about vxWorks?  Do I
have to modify the iocCore vxworks makefile?

Thanks in advance.

Geoff Savage

Navigate by Date:

Prev: EPICS postdoc position available _mm_/o~.~o_mm_

Next: RE: Building EPICS on Linux Hammonds, John

Index: 1994  1995  1996  1997  1998  <1999>  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 

Navigate by Thread:

Prev: EPICS postdoc position available _mm_/o~.~o_mm_

Next: RE: Building EPICS on Linux Hammonds, John

Index: 1994  1995  1996  1997  1998  <1999>  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024