I have a few questions about how EPICS handles GPIB devices. My goal is
to understand how to send GPIB commands to devices. I am running EPICS
version R3.12-LBL.1, vxWorks version 5.3, and my GPIB controller board is
a National Instruments National GPIB 1014-DP.
My current understand is that one writes a device support entry table,
such as devAik486Gpib.c, with all of the GPIB commands enclosed in
parameter tables, and then uses a standard record instance, with a DTYP
that matches this device support entry table.
If I am totally off on this, I would like to have a step-by-step procedure
of how to send these commands.
Thanks,
Robert Willson
[email protected]
- Navigate by Date:
- Prev:
RE: Fatal GDD deficiencies Jeff Hill
- Next:
Re: GPIB devices Mark Rivers
- Index:
1994
1995
1996
1997
1998
1999
<2000>
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Java Chip Watson
- Next:
Re: GPIB devices Mark Rivers
- Index:
1994
1995
1996
1997
1998
1999
<2000>
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
|