Subject: |
No HomeStatus and No Motion with OMS MAXv : Motor 6.5.1 / VxWorks 6.8 / base 3.14.11 |
From: |
Jerome HOSSELET <[email protected]> |
To: |
[email protected] |
Date: |
Mon, 11 Oct 2010 17:08:02 +0200 |
Hi all,
I have some troubles with a motor driver v 6.5.1 and EPICS base 3.14.11 and VxWorks 6.8
VxWorks 6.8 : install ok
Base EPICS 3.14.11 : compilation ok
Support motor 6.5.1: compilation ok
I use a MAXv-4000 with a servo configuration (PSM configuration).
When i use a VxWorks 6.7 and motor 6.4.4 and base 3.14.8.2 => all it's ok
but when i move in last release all package it doesn't works.
The home status : ATHM always = 0
During the motion a message appear Motion = "Move" && "Communication error"
When i check my analogic output for motor 1 (commande analogic to the servo)
I probe always 10 V.
It's not normal ......
Ron or other can i help me ?
Jerome HOSSELET
[email protected]
- Replies:
- Re: No HomeStatus and No Motion with OMS MAXv : Motor 6.5.1 / VxWorks 6.8 / base 3.14.11 Ron Sluiter
- Re: No HomeStatus and No Motion with OMS MAXv : Motor 6.5.1 / VxWorks 6.8 / base 3.14.11 Andrew Johnson
- Navigate by Date:
- Prev:
Re: StreamDevice-2-4 compile error Martin Konrad
- Next:
Timeout errors with ASYN Modbus Driver 2.0 David Dudley
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
<2010>
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Re: StreamDevice-2-4 compile error Martin Konrad
- Next:
Re: No HomeStatus and No Motion with OMS MAXv : Motor 6.5.1 / VxWorks 6.8 / base 3.14.11 Ron Sluiter
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
<2010>
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
|