Does setting the SmartStageName to an empty string prevent the XPS's
"Auto configuration" from auto-detecting which axis is connected to a
channel?
Do you configure your XPS controllers manually?
Kevin
On 7/12/15 4:51 PM, Mark Rivers wrote:
> Note that I have commented out the line
>
> ;SmartStageName = UTS100CC
>
> and replaced it with:
>
> SmartStageName =
- Replies:
- RE: Stepper Motor Controllers Mark Rivers
- References:
- Stepper Motor Controllers Mark Davis
- Re: Stepper Motor Controllers Mark Rivers
- Re: Stepper Motor Controllers Kevin Peterson
- Re: Stepper Motor Controllers Mark Rivers
- RE: Stepper Motor Controllers Mark Rivers
- Navigate by Date:
- Prev:
StripTool Current Value Following IOC Reboot Poff, Mark A
- Next:
RE: Stepper Motor Controllers Mark Rivers
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
<2015>
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
RE: Stepper Motor Controllers Mark Rivers
- Next:
RE: Stepper Motor Controllers Mark Rivers
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
<2015>
2016
2017
2018
2019
2020
2021
2022
2023
2024
|