Hi Ben,
On 01/30/2018 04:15 PM, Benjamin Franksen wrote:
Does a caput from the command line work also result in an error message?
using caput results in the same error message.
I added the OMSL field with "supervisory" to the binary output record,
but still fails.
Since I do not care, if it is output or input PV, I can switch. But it
would be nice, to understand this problem.
Best regards,
Simon
--
Simon Reiter
II. Physikalisches Institut
Justus-Liebig-Universtität
Heinrich-Buff-Ring 16
D-35392 Giessen
Tel: +49 641 99 33250
- Replies:
- Re: pvPut error message by Sequencer Andrew Johnson
- References:
- Scanning on event number fails with EPICS 3.16 Simon Reiter
- pvPut error message by Sequencer Simon Reiter
- Re: pvPut error message by Sequencer Benjamin Franksen
- Navigate by Date:
- Prev:
Re: pvPut error message by Sequencer Ralph Lange
- Next:
Re: pvPut error message by Sequencer Benjamin Franksen
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
<2018>
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Re: pvPut error message by Sequencer Benjamin Franksen
- Next:
Re: pvPut error message by Sequencer Andrew Johnson
- Index:
1994
1995
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
<2018>
2019
2020
2021
2022
2023
2024
|