Experimental Physics and
Industrial Control System

Hello Bo

Can you give examples for the two different replies? Is there any information in the replies you want to use? Can there be any error-replies (e.g. something like „cannot switch on right now“)?

Dirk

> Am 23.05.2024 um 21:19 schrieb boj via Tech-talk <tech-talk at aps.anl.gov>:
> 
> Dear all
> 
> I am implementing a StreamDevice based IOC for a "CryoTel GT Cooler", which in general is very easy to communicate with, but has some strange behaviors for
> the startup and shutdown commands.
> 
> I need to send one of the following commands:
> 
> SET SSTOP=1
> 
> or
> 
> SET SSTOP=0
> 
> However, the response is different in the two cases.
> 
> I think a "BO" record, should be used, but is there anyway I can have different protocol definitions for the "1" and "0" state?
> 
> Alternatively, is there an easy way to separate this into two records?
> 
> Thanks in advance
> 
>    Bo

Navigate by Date:

Prev: Re: CryoTel GT Cooler: different startup and shutdown StreamDevice protocols Ralph Lange via Tech-talk

Next: Re: CryoTel GT Cooler: different startup and shutdown StreamDevice protocols boj via Tech-talk

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  <2024> 

Navigate by Thread:

Prev: Re: CryoTel GT Cooler: different startup and shutdown StreamDevice protocols boj via Tech-talk

Next: PyDevice support VAL field remains 1 Vishnu Patel via Tech-talk

Index: 1994  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  <2024>