Hi,
Before I ask a question, I would like to thank the epics tech talk for helping me. I’m a beginner in epics and RTOS, but I was able to come to this step with a lot of help. Really appreciate it.
I try to boot MVME6100 with epics st.cmd, MAXv controller. But it shows me a error like this :
Done executing startup script 'host:/usr/local/epics_motor/synApps_5_8/support/motor-6-9/iocBoot/SX_PTL_motor/st2.cmd'.
-> save_restore: connect failed for channel 'BL:SX:EH:ATT1:M1.DVAL'
save_restore: connect failed for channel 'BL:SX:EH:ATT1:M1.DIR'
save_restore: connect failed for channel 'BL:SX:EH:ATT1:M1.DESC'
….
…
save_restore: connect failed for channel 'BL:SX:EH:ATT1:M2.SREV'
save_restore: connect failed for channel 'BL:SX:EH:ATT1:M2.UREV'
save_restore: connect failed for channel 'BL:SX:EH:ATT1:M2.CNEN'
SX_PTL_settings2.sav: 0 of 106 PV's connected
So I think this error is related to st.cmd, wrong set address about MAXvSetup.(I guess)
I set up this st.cmd maxvsetup like this:
MAXvSetup(1, 16, 0x1000, 0, 5, 10)
And my Maxv controller jumper set is like this:
J12 Mode: A16
J12 IRQ : IRQ5
J13 left : A29, A30, A31
J13 right : AM1, AM2, AM4
I set the 8 jumpers on the left of J13 like this and put a value MAXvSetup(1, 16, 0x1000, 0, 5,10). I read Maxv User Manual as well, but I still don’t understand about this.. Do you have any solution about this?